Making Labels with Bar Codes

The following are step-by-step instructions for making a bar code label with the Labelizer Plus.

1. Insert ½" black on yellow tape in the Labelizer Plus.
   
   
2. Check the Label Options settings. They should be:
   
   

   Justification - Center Text Position - Middle Frame Label - Off Frame Area - Off Reverse Print - Off

   Text Direction - Character Spacing - Normal Line Spacing - Normal Mirror - Off Baseline - Center

   
   
   The above are the correct settings. If your Labelizer Plus does not have these settings selected, use the up/down arrows to select the correct setting, then use the left/right arrows to change the setting. When done, push
   
   
3. Turn the CAP LOCKS on.
   
   
4. Insert the 3 OF 9 BAR CODE POWER CARD into a side slot in the Labelizer Plus.
   
   
5. Hold down the SHIFT key and push BARCODE (selects the bar code settings)
   
   
6. Select the following settings:
   
   
   • Height - .25
   • Start/Stop - Off
   • Density - 20 mil (normal)
   • Check Character - Off
   • HR Text - Below
   
   
7. Push
   
   
8. Enter .25 as the TYPE SIZE, and push .
   
   
9. At the cursor
   
   
10. Type: BIN A7, then push the space bar.
    
    
11. BAR CODE, 3 of 9, push
    
    
12. Type: 1009-A7, BAR CODE, then push the space bar.
    
    
13. TYPE SIZE, .1 , At cursor
    
    
14. Type: 2" LAG BOLTS
    
    
15. PRINT PREVIEW
    
    

Using The Brady Labelizer Plus

MORE BRADY LABELIZER PLUS SUPPLY INFORMATION:
 Introduction (home) | Ordering Brady Labelizer Plus Supplies

Give us a call today at 1-800-788-5572 to learn more about DuraLabel sign and label printers.